Squash rewards people who keep turning up for years

Box leagues, club championships, county draws, then the veterans brackets after that. Nothing arrives in a batch. It is one medal every few months across a decade, which is the pattern that quietly fills a shoebox.

A wall display fixes that by giving each new one an obvious place to go. This medal display is cut from a single sheet of stainless steel with the racket and player silhouette, and the mounting kit is in the box.

Squash players tend to buy this for themselves late, after twenty years of playing, which means the collection is already large on day one. Measure the drawer before choosing.

This medal holder comes in the widths listed here. For a gift, err wide — nobody has ever complained about too much room.

Size & capacity

Not sure which size?

If the medals already exist and the player is past forty, buy for what is there plus about a third. If they are twenty, buy the widest and stop thinking about it. This design is produced from 45 cm upwards — the cut-out detail doesn't hold at smaller widths.

The steel, and why it matters

Every medal display in the range is AISI 304 — the same grade used for kitchen surfaces and marine fittings — at 2.5-3 mm depending on width. It doesn't rust, doesn't chip, and doesn't need looking after.

The bar is continuous. That's the whole difference from a hook rack: hooks give you a fixed count, a rail gives you a length.

Fitting it to the wall

Comes with stainless standoffs, fixings and a paper drilling template. On plasterboard use proper anchors rather than the plugs supplied — a full display is heavier than it looks.

When it fills up

A second unit mounts flush against the first, so the wall still reads as one piece rather than two things hung near each other. The widest version holds up to 110 medals across three rails.

Delivery

Every medal display is cut and finished in our own workshop and dispatched within 3–5 working days. Returns accepted for fourteen days.