The women's cut of the tennis design

Same steel and the same rail as the rest of the range, drawn with the women's silhouette. It matters more than it sounds: a gift that shows the wrong figure gets a polite thank you and a shelf.

Sizing is the thing worth getting right. Most people buy too small, because they count the medals they have rather than the ones coming. Count what's in the drawer, then go one width up.

Worth knowing before you buy: this design has fine cut-out detail around the racket. It holds at every width in the range, but on the 35 cm it reads as texture rather than as a clear silhouette from a distance.

This medal hanger is produced in the widths below. If you are buying it as a gift, size on the collection they already have rather than on what looks right on the wall.

Size & capacity

Not sure which size?

If it's going in a hallway where people pass close, 45 cm is enough. Across a room, go to 60.

Made from one sheet, not assembled from parts

The medal holder is laser-cut from a single piece of AISI 304 stainless steel, 2.5-3 mm thick depending on the width. Nothing welded on, nothing to come loose.

Medals hang on a continuous rail rather than individual hooks, so you're limited by the width of the bar and nothing else.

Mounting

Everything is in the box: stainless standoffs, screws, wall plugs and a paper template. Mark through the template, drill, done — about ten minutes.

Running out of room

Buy a second and line it up directly beneath or beside this one — the proportions are designed so a pair looks intentional. The widest version holds up to 110 medals across three rails.

Getting it to you

This medal holder is made to order in the EU and on its way within 3–5 working days, with fourteen days to send it back if it isn't right.